iMOTION™ integrated power module (IPM)
Within the iMOTION™ IPM family, there are two different series: The IMM100 and IMI110, which combine the motor controller IC and a three-phase inverter stage in a single package, minimizing
AND9390
Compact IPM series modules use an external shunt resistor for the OCP functionality. As shown in Figure 9, the emitters of all three low−side IGBTs are brought out to module pins.
10A 1200V 3-phase inverter IPM
New SLLIMM high power IPM extends voltage levels to 3-phase mains-powered motor drives with simplified design and reduced BOM. This new intelligent power module is part of the high power
250W motor inverter reference design with GaN IPM DRV7308
This reference design illustrates a 250W high efficiency motor inverter without heat sink based on GaN IPM DRV7308, also demo a low standby power design with UCC28911.
New Generation of IPM
Fuji Electric has developed a compact high capacity intelligent power module (IPM)*1 which is ideally suited for large capacity air conditioning systems, industrial inverters, and servo
Intelligent Power Module
Offering a large range of 3 Phase inverter modules covering power levels from 50 W to 10 kW. Available in different topologies including PFC and input bridge rectifier.
Datasheet
Each fault enables the SD open drain for a different time, as described in the following table.
IPM Ref Design for Inverters Using Single-Package Six-Channel
This reference design shows the functionality of the three-phase inverter implemented using an IPM. A six-channel digital isolator based on capacitive technology is used for PWM isolation, and isolated
3‐phase Inverter Power Module 1200 V SPM 31 Series
This series of Intelligent Power Modules (IPM) for 3-phase motor drives contains a three-phase inverter stage, gate drivers. The SPM 31 design objective is to provide a minimized package and a low power
“PFC + Inverter” IPM (Intelligent Power
A PFC+Inverter IPM (Intelligent Power Module) optimized for low power Drives is introduced. A three phase inverter and a single boost PFC stage are integrated in one single miniaturized DIL (Dual-In
Low-Voltage Battery Racks
48V LiFePO4 racks from 5kWh to 30kWh, scalable for home energy management and backup power – ideal for residential and light commercial.
DC Combiner Boxes
1500V DC combiner boxes with surge protection, fuses, and monitoring – essential for large solar arrays and source-grid-load-storage integration.
Smart Microgrid Systems
Islanding controllers, genset integration, and real-time optimization for microgrids, reducing diesel consumption and improving reliability.
Outdoor Cabinets & Battery Racks
IP55 temperature-controlled cabinets with active cooling/heating, housing modular battery racks for harsh environments.